Ceiling ports execute a qualified extraction of grease, smell and moisture by cooking on an island range and cooktop made. You’ll must build strong framing for the port in your current ceiling joists as island range ports can readily weigh 100 lbs or even more. An assistant can assist you to hoist the port into area for setup that is final. Purchase the right kit for the port -, 9- or 10-foot ceiling heights.
Assess the ceiling, as well as the space between the area, preferably 36-inches over the ground, without the the producer ’s detailed peak for the island cooker port. The port hood must be set up over the cooking area — depending on the producer’s directions — between and 24 inches.
A piece of paper on the other side of the ceiling joists over the cooking area. Drop a plumb-bob on a string to every corner of the area beneath, marking the paper above using the abstract of the area. The producer’s on where to put the port’s hood in connection to the cook top area directions; it may be made to over hang the cooking area by 1 ½ inches to snag vapors that are isolated.
Add marks that are added to the paper to notice the location of its own duct and the port hood . Draw on a circle to symbolize the duct, usually 6 inches in diameter. Draw on the locations of 2by4 cross-pieces on both sides of the duct, no matter what the producer sets in the directions, or spaced three-quarters of an inch from every side of the duct. Transfer the marks for the cross-piece locations in the paper to the ceiling joists.
Cut 2 by 4 lumber on a chop saw to fit snugly between the ceiling joists. Check the crosspieces are level using a spirit-level, exploiting on the crosspieces down or upward to make them level. Screw four No. 10 wood screws, 3″ long, through the ceiling joists in to each end of the cross-piece.
Install 6-inch round duct or a different size advocated by the manufacturer that is vent, utilizing the most direct path possible, to wall or the roofing, including wall cover or a roof port with damper at the conclusion of the operate.
Run wiring out of your circuit breaker or have this job is performed by an electrician if you’re not experienced in work. Install gypsum board in order to complete the ceiling. Notice the locations of the ceiling joists and cross pieces having an electronic stud-finder and mark these on the gypsum board using a carpenter’s pencil.
Set the producer’s templet contrary to the ceiling, aligning the four mounting holes together with joists and the cross-pieces. Hammer a nail-set during the holes in the template and to the ceiling. Drill pilot holes for the screws, preferably in the middle of joists or the cross-pieces. Reduce having a dry wall and Mark saw the opening for the duct — usually circle and A1-inch wire accessibility hole as specified from the templet. Pull the wiring through the accessibility hole.
Screw the assistance framework of the port with you as well as your helper working to contain the the hefty framework in spot, to the pilot holes and push the screws. Install the low support body onto the top support framework and loosely connect it with the supplied screws and washers. Fix the support framework that is low to the suggested height over the cooking area and tighten the screws.
Lift the port hood to the low support framework together with assistance from your helper and direct the port duct connector to the end-of the duct. Tighten lockwashers and the nuts with the adjustable wrench. Join the cable after the producer’s directions and utilizing the producer’s supplied wire nuts.